Broan EW5630SS Installationsanleitung PDF herunterladen (Seite 7)

MODELS EW5630SS • EW5636SS

Page 7

Always turn the hood ON before cooking in order to establish an air

flow in the kitchen. After turning off the range, let the hood run for a

few minutes to clear the air.

Operate the hood as follows:

OFF

Turns the fan OFF

FAN (1-Pushbutton Switch, 3-Fan Speeds)

Turns the fan ON to the last selected speed, and activates a blue LED

indicating the fan speed setting. Pressing the FAN button a second

time will index the fan speed and LED indicator to the next highest

setting. Pressing the FAN button when the fan is at the highest speed

setting will index the fan and LED indicator to the lowest setting.

DELAY-OFF (10 Minute Delay-OFF)

Activates the 10 minute delay off feature when the fan is ON (any

speed). When activated, the blue LED indicator above the selected

speed setting will blink. The hood fan will automatically turn OFF after

10 minutes has elapsed. The DELAY-OFF button can be pressed at

any time during the 10 minute countdown to turn off the feature.

LIGHT (1-Pushbutton Switch, 3-Light Intensities)

Turns the lights ON to the lowest intensity. Pressing the LIGHT button

a second time will index the light intensity to the next highest level.

Pressing the LIGHT button when the lights are at the highest intensity

will turn the lights off.

FILTER CHANGE INDICATION

After 30 hours of fan operation, the three blue LED indicators will blink

simultaneously, indicating that it is time to clean the grease filters.

To reset the filter clean timer, press and hold the OFF button for 3

seconds. The blinking LED indicators will turn off.

HEAT SENTRY SYSTEM

This range hood is equipped with a standard Heat Sentry system

that monitors excessive temperature and automatically turns the fan

speed on HIGH.

1) If the fan is ON, the Heat Sentry system will increase the fan

setting to its highest speed when the temperature is elevated.

The blue indicator for fan speed (3) will illuminate and blink at

a high rate, indicating that the heat sentry function is activated.

Once the temperature has reduced, the Heat Sentry system will

change the fan speed to the original setting.

If the fan is OFF, the Heat Sentry system will automatically turn the

fan on to its highest speed when the temperature is above normal.

The blue indicator for fan speed (3) will illuminate and blink at a

high rate, indicating that the heat sentry function is activated. After

the temperature has lowered to normal, the fan will turn off.

FUSES

The Range Hood Control Board contains a Main Fuse to protect

the controls from power surges. New fuses can be purchased at a

local electronic supply store. Use 5A, 250V, 5 mm diameter, 20 mm

long, fast-acting, cartridge-type fuses. To replace a fuse (by qualified

person(s): 1. Disconnect power at service entrance. 2. Remove

decorative flues. 3. Remove control cover. 4. Remove and inspect fuse.

OPERATION

OFF FAN

DELAY

OFF

LIGHT

FAN SPEED

LED INDICATORS

12. Measure and install section of flexible metal ductwork

(included with RKE56) to hood duct connector and bottom

of non-duct plenum. Use duct tape to make all joints secure

and air tight.

CAUTION

Do not use plastic duct.

13. Plug power cord into wall outlet.

DUCT LENGTH

DECORATIVE

FLUE

6” ROUND

FLEXIBLE

METAL DUCT

NON-DUCT

PLENUM

14. Slide the upper decorative flue section into the lower

decorative flue section. NOTE For non-ducted applications,

the upper flue should be oriented so the louvers are towards

the ceiling.

15. Carefully place the upper/lower flue assembly into the

recessed area of the hood.

16 Slide the upper flue upward until it is aligned with the non-

duct plenum. The non-duct plenum should be inside the flue.

Secure the upper flue to the non-duct plenum using (2) 4mm

x 12mm mounting screws.

NOTE

9-10 ft. ceilings may require Flue Extension Model

FXNE56SS depending on installation height (purchase

separately). Discard the upper and lower flues supplied

with your hood and replace them with Flue Extension

Model FXNE56SS.

1 2 3 4 5 6 7 8 9 10 11 12 ... 27 28

Kommentare zu diesen Handbüchern

Keine Kommentare

Broan EW5630SS Installationsanleitung Seite 7

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Dunstabzugshauben Broan EW5630SS