Broan EW5630SS Installationsanleitung PDF herunterladen (Seite 4)

MODELS EW5630SS • EW5636SS

Page 4

Flush with

the ceiling

Center of

installation

Upper flue mounting

bracket slots

Ceiling

INSTALL THE HOOD

(Ducted Hoods Only)

1. Center the flue mounting bracket over the hood location and

flush with the ceiling. Secure the upper flue bracket to the

wall using (2) 4mm x 38mm mounting screws. Note: Drywall

anchors may be needed (not included).

2. Tighten the screws completely. Make sure that the bracket is

tight against the wall and ceiling.

3. Remove (2) screws holding electronics mounting bracket to

hood. Rotate bracket 180 degrees and re-attach bracket to

hood with same (2) screws.

4. Remove the protective plastic film covering the decorative

flue and the hood at this time.

5. Remove the grease filter by pulling down the metal latch tab

and tilting filter downward to remove.

6. Align the keyhole slots on the hood with the mounting screws

that were partially tightened into the wall framing. Ensure that

hood is seated entirely on mounting screws, and that hood is

level. Then tighten screws completely.

7. Install (2) 4mm x 38mm long screws into the holes inside the

hood and tighten them securely.

8. Carefully place glass canopy on top of the hood. Align nuts

on glass canopy with holes inside the hood. Attach canopy

with (4) .188” x .250” long flat head screws. Tighten screws

securely but DO NOT OVERTIGHTEN.

9. Reinstall grease filter by aligning side filter tab with slots

in the hood. Pull down the metal latch tab, push filter into

position and release. Make sure filter is securely engaged

after installation.

1 2 3 4 5 6 7 8 9 ... 27 28

Keine Kommentare

Broan EW5630SS Installationsanleitung Seite 4