Broan B5936SS Installationsanleitung PDF herunterladen (Seite 2)

MODEL B5936SS

Page 2

INSTALL THE DUCTWORK

(Ducted Hoods Only)

1. Decide where the ductwork will run between the hood and

the outside.

2. A straight, short duct run will allow the hood to perform

most efficiently.

3. Long duct runs, elbows and transitions will reduce the

performance of the hood. Use as few of them as possible.

Larger ducting may be required for best performance with

longer duct runs.

4. Install wall cap or roof cap. Connect round metal ductwork

to cap and work back towards the hood location. Use duct

tape to seal the joints between ductwork sections.

MEASURE THE INSTALLATION

The minimum hood distance above cooktop MUST NOT BE

LESS than 30”.

A maximum of 36” above cooktop is highly recommended for

best capture of cooking impurities.

Distances over 36” are at the installer and users discretion;

providing that the ceiling height permits.

NOTE:

On 8-ft. ceilings

Hood distance above cooktop is:

Minimum 30”, Maximum 32¼” (for ducted discharge)

Minimum 30”, Maximum 30½” (for non-ducted discharge)

On 9-ft. ceilings

Hood distance above cooktop is:

Minimum 30”, Maximum 36” (for both ducted and non-ducted

discharge).

On 10-ft. ceilings

Hood distance above cooktop is:

Minimum 30”, Maximum 36” (for both ducted and non-ducted

discharge).

NOTE: 10-ft. ceilings require 10-ft. Flue Extension, Model

FXN59SS for ducted or non-ducted installations (purchase

separately).

PREPARE THE HOOD

ROOF

CAP

DECORATIVE

FLUES

EAVE

VENT

6” ROUND

ELBOWS

6” ROUND

DUCT

HOOD

30” TO 36” ABOVE

COOKING SUFACE

HOOD

CENTER

LINE

DUCT CENTER LINE

(1-3/4” to rear of hood

centerline)

Unpack hood and check contents. You should receive:

1 - Hood

1 - Metal Canopy

1 - Decorative Flue Assembly (2 pcs.)

1 - Damper / Duct Connector

1 - Ceiling Mounting Plate

8 - Angle Brackets

2 - Aluminum Grease Filters (installed in hood)

1 - Parts Bag containing:

8 - Mounting Screws (M6 x 40mm Pan Head)

46 - Machine Screws (M4 x 8mm Pan Head)

20 - Serrated Flange Nuts (M4)

8 - Sheet Metal Screws (M4 x 8mm Phillips Head)

3 - Wire Nuts

M4 x

8 mm

M4 x 8 mm

Sheet Metal

M6 x

40 mm

Wire Nut

Serrated

Flange

Nut

1 2 3 4 5 6 7 ... 27 28

Kommentare zu diesen Handbüchern

Keine Kommentare

Broan B5936SS Installationsanleitung Seite 2

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Dunstabzugshauben Broan B5936SS