LIGHTS UP when the intermittent
mode has been selected.
FLASHES when maintenance is
required (see Section 3).
LIGHTS UP
when the
system is
operating
(exhausting
stale air from
the house
and drawing
in fresh air).
LIGHTS UP when the
control has detected
excess humidity. This
forces the motor to
operate at high speed.
The light indicator
turns off when the
humidity drops to the
level associated with
the temperature
selected on knob B.
2.6 USING THE DEHUMIDISTAT MAIN CONTROL
Location: Located in the busiest area of the
house.
Purpose: To reduce condensation on windows.
During fall, winter and spring:
Adjust knob A to the desired maximum humidity
level.
NOTE: Do not select a level below 30%. This
could lead to excessive dryness in the
air causing discomfort for the occupants.
During summer:
Adjust knob A to the “OFF’’ position or to the
highest humidity setting if there is no “OFF’’
position on your control.
Location: Located on the side of the unit, only on models HRV100H and HRV200H.
Purpose: To adjust air supply.
How to operate the unit on a daily basis:
Select “LOW’’ or “HIGH’’ speed:
• Select “LOW SPEED’’ for normal daily operation.
• Select “HIGH SPEED’’ for excess pollutants and
humidity (parties, odors, smoke, etc.)
How to turn the unit off: Select the “REMOTE’’ position.
NOTE: If the HRV100H or the HRV200H is connected to VT1W main control,
the 3-position switch must be in “REMOTE’’ position.
INDOOR HUMIDITY LEVEL.
Kommentare zu diesen Handbüchern