User ManualVENTILATION SYSTEMSVB0065vänEE Canadian Model Numbers 1001 ERV 1001 HRV* 2001 ERV 2001 HRV*Broan U.S.A. Model NumbersHRV100HHRV200HERV100HC
2.2 USING THE PLATINUM MAIN CONTROL (CONT’D)SETTING PREFERENCESPress on MODE / PREF key (D) for 3 seconds.NOTE: You can exit Preferences setting by pr
2.2 USING THE PLATINUM MAIN CONTROL (CONT’D)SETTING PERIODS FOR PROGRAM MODEDAILY PERIODS DEFAULT SETTINGSPERIOD STARTING HOUR MODEPERIOD 1 (MORNING)
2.3 USING THE DECO-TOUCH MAIN CONTROL12VC0117OROPERATING MODESOFFPut the unit on stand-by mode, so it will only respond to auxiliairy controls (if p
2.2 USING THE PLATINUM MAIN CONTROL (CONT’D)13HOW TO SET THE RELATIVE HUMIDITY (RH) LEVEL AND CHOOSE BETWEENOFF IN STANDBY OR RECIRCULATION IN STAND-B
2.2 USING THE PLATINUM MAIN CONTROL (CONT’D)14DEHUMIDISTAT OVERRIDE SELECTIONIn the operating modes MIN, MAX, 20 MIN/H and RECIRC, the user can select
15Location: Located in the busiest area of the house.Purpose: To adjust air supply and reduce condensation on windows.ADJUSTING THE AIR SUPPLY CONTROL
162.5 USING THE VT2W MAIN CONTROLLocation: Located in the busiest area of the house.Purpose: To adjust air supply and reduce condensation on windows.A
172.5 USING THE VT2W MAIN CONTROL (CONT’D)UNDERSTANDING THE LIGHT INDICATORSAIR SUPPLY CONTROLCONDENSATION CONTROLMAXIMUM SPEEDAIR EXCHANGE IN PROGRES
18Location: Located in the bathroom or in other locations where there is temporaryexcess humidity or pollutants.Purpose: To eliminate excess humidity
191. Disconnect the power supply.2. Unlatch the door. Lift the pannel towardsyou. Hold it firmly and hit on the right sideof the pannel. The door shou
The purpose of this manual is to help you with the use of your unit. Section 2 (How toOperate the Unit Using Controls) shows you how you can operate t
203.1 EVERY THREE MONTHS (CONT’D)5. Clean the condensation tray with a dampcloth.6. Check the exterior air intake hood:• Make sure there are no leaves
3.2 ANNUAL MAINTENANCE (FALL) (CONT’D)213. Put the components back in place (Section 1.1):• Blower assembly (blower motor wires, wing nut)• Recovery c
TYPE OF PROBLEM TRY THIS...1. On Platinum wall control, • At its very start-up or after a power failure, it there is no outside takes some minutes
1.YOUR UNIT AND ITS PURPOSE ...4-61.1 Unit Description...
1.1 UNIT DESCRIPTION41. YOUR UNIT AND ITS PURPOSEYour ventilation system is designed to provide fresh air, warmed outdoor air to your homewhile exhaus
• Units equipped with a heat and humidity recovery core (enthalpic core) can reduceventilation costs in winter as well as in summer.1. During the heat
6When the outside temperature is below 0°C (32°F), recovery (of heat or energy) createsfrost in the core. To maintain its proper operation, the unit i
72.1 INSTRUCTIONS REGARDING YOUR CONTROL DEVICESRefer below and on the following page to identify which controls are installed in your house.Then, go
2.1 INSTRUCTIONS REGARDING YOUR CONTROL DEVICES (CONT’D)OPTIONAL CONTROLS20-minute push-button timer . . . . . . . . . . . . . . . . .Page 18ONVC0030
2.2 USING THE PLATINUM MAIN CONTROLVC00998 91323124567SMART Mode. Entirely automatic modeoptimizing the ventilation.Temperature Indicators.Program Mod
Kommentare zu diesen Handbüchern