Broan HRV100H Bedienungsanleitung PDF herunterladen (Seite 16)

2.5 USING THE VT2W MAIN CONTROL

Location: Located in the busiest area of the house.

Purpose: To adjust air supply and reduce condensation on windows.

ADJUSTING AIR SUPPLY CONTROL

a) Press “PUSH” (A) until the “MIN.”, “MAX.” or “INTERMITTENT” light indicator appears.

• When “MIN.” (minimum speed) is

selected, if the knob B is set above

the click, the unit will exchange in

low speed with the outside and if it is

set below the click, the unit will

exchange on high speed with the

outside until the desired humidity

level has been reached.

• When “MAX”. (maximum speed) is

selected, the unit will exchange on

high speed with the outside either if

the knob B is set below of above the

click.

• Select “INTERMITTENT” (20 minutes

minimum speed exchange every

hour) when you are away from the

house for a few days or when you

deem the inside air too dry.

b) To turn the unit off , press “PUSH” (A) until the “MIN.”, “MAX.” and “INTERMITTENT”

light indicators are all turned off.

NOTE: Optional controls will still be active. (Indicator (C) will be the only one to light up if

an optional control is active).

ADJUSTING CONDENSATION CONTROL

Setting during the summer months:

Normally there is no condensation on your windows during this period which therefore

eliminates the need of the condensation control for a few months. Set knob B at the

“SUMMER’’ position during this period.

Setting during the fall, winter and spring months:

Ideally, maintain humidity level within the “Comfort Zone” (between 5°C and -20°C), which

is the dark area around knob B.

To reduce humidity level, turn knob B clockwise a notch below the click. The unit will then

switch to high speed, lighting up the humidity light (D indicator). When this light goes "OFF"

(after a few hours or a few days), repeat the same procedure if excess humidity persists.

NOTE: If the air is too dry, set your knob B back to the “Comfort Zone” and use INTERMITTENT

or turn off the unit.

When the humidity light (D indicator) goes "ON", you can still change the mode of operation

but your change will take place only when the light goes OFF.

-20°C

-4° F

-5° C

23°F

°C

41°F

CONDENSATION CONTROL

AIR SUPPLY CONTROL

CONDENSATION CONTROL

MAXIMUM SPEED

AIR EXCHANGE IN PROGRESS

MIN. MAX.

CONTINUOUS INTERMITTENT

20 MIN.

40 MIN.

OFF

VC0028

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 22

Kommentare zu diesen Handbüchern

Keine Kommentare

Broan HRV100H Bedienungsanleitung Seite 16

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Luftfilter Broan HRV100H