Broan 332H Installationshandbuch

E60000 SERIESINTENDED FOR DOMESTIC COOKING ONLYINSTALLER: LEAVE THIS MANUAL WITH HOMEOWNER.HOMEOWNER: USE AND CARE INFORMATION ON PAGE 13 AND 14.Broan

- 10 -1. Drywall2. Wood mounting strip3. Flat head screw4. Wall anchor location5. Back of hood outline6. Wall studs10. INSTALL WOOD MOUNTING STRIPMeas

- 11 -14. ROUGH-IN PLATE LOCATION (EXTERNAL BLOWERS HOODS ONLY)Run power cable to installation location. For ducting through top of hood, existingplat

- 12 -Reinstall grease drip rail. The illustration beside shows how to reinsert the greasedrip rail into the range hood.17. REINSTALL GREASE DRIP RAIL

- 13 -19. USE AND CAREBaffle FiltersThe baffle filters should be cleaned frequently. Use a warm detergent solution. Wash more often if your cooking st

- 14 -COOKTOP LIGHTING (HALOGEN)A rotary 3-position knob (1) controls the halogen lights (OFF - low intensity - high intensity).BLOWERThe blower is op

- 15 -22. WIRING DIAGRAMSBroan Elite E60000 SeriesInternal blower(s) hoodsBroan Elite E60000 SeriesExterior or In-Line blower hoodsLINENEUTRALGROUND12

- 16 -23. SERVICE PARTSBroan Elite E60000 SeriesInternal blower hoodsBroan Elite E60000 SeriesExterior or In-Line blower hoods* NOT SHOWN.* NOT SHOWN.

- 2 -TO REDUCE THE RISK OF FIRE, ELECTRICSHOCK OR INJURY TO PERSONS, OBSERVETHE FOLLOWING:1. Use this unit only in the manner intended by the manufact

- 3 -HL0099RMP SERIESBACKSPLASH(STAINLESS STEEL WALLCOVERING WITH WARMINGSHELVES. OPTIONAL)MODEL 427 (4½” X 18½” TO 10” ROUND, 6” HIGH - LATERALMODEL

- 4 -HL0100- E60000 SERIES RANGE HOOD SYSTEM -IN-LINE AND EXTERIOR BLOWERSRMP SERIES BACKSPLASH(STAINLESS STEEL WALL COVERINGWITH WARMING SHELVES.OPTI

- 5 -1. SELECT BLOWER OPTION AND INSTALLATION TYPE1.2 DUCTED INSTALLATIONThe Broan Elite E60000 Series range hood includes many configurations: hoods

- 6 -Remove the installation kit from inside the hood.Make sure that the following items are included:-Wood strip (attached to back of hood)-Installat

- 7 -3. PREPARE THE INSTALLATION (CONT’D)Cut-out the openings for duct (A) and power cable (B), in cabinet or wall, according to the direction of disc

- 8 -5. CHOOSE THE OPENING(S) (INTERNAL BLOWER(S) HOOD ONLY)Remove the knockout(s) for the chosen opening(s) (horizontal at the back of the hood or ve

Rotate the blower and engage itsflange in the back wall retainingbracket.Using a 5/16” socket and thescrews previously removed, securethe blower to th